But as we shall see in this section, there are some solutions you can try that will get the device working normally again. Factory Reset The Samsung Deviceīecause the problem can be so hard to understand, most people think it is difficult to fix. Fix Samsung Purple Screen with One Clicks This could be a hardware issue that could result from a fall that may, in turn, affect the functionality of the software. In layman's terms, you may be seeing the purple screen because there is a critical error on your device that is preventing the software on your device from functioning correctly. The purple screen of death is an indication that the VMK kernel of the EXX/ESXi host is experiencing a serious error and becomes inoperative, terminating virtual machines that may be running. If this is the problem you are experiencing, this article is aimed at helping you troubleshoot and hopefully fix the device once and for all.īefore we get to the solutions, however, it is important to note that this problem can be caused by both software and hardware problems and the solution used to fix the problem will depend on the main cause. At first, the purple color can appear a small spot on the screen, but over time the small spot tends to grow darker and larger, just like your screen is bleeding until the whole screen is covered. The purple screen is one of the most common problems to affect Samsung devices and can be quite problematic.
The patch grew in the next few days to cover the whole screen and I was unable to use the device properly. After a while, I noticed a small patch of the screen had become a kind of purple-blue color. There was no screen damage of any kind from the fall and I was grateful my device was still functional. Off the subject.I lent my Samsung Galaxy Note 5 to a friend of mine who dropped it from a considerable height. My pressure points were at the bottom left and right of the screen so MOST of my clips at the bottom are gone apart from a few in the middle which hold it all flat still so looks no different.Īlso. When I found which ones were applying the pressure, I used a pair of plyers to grip and twist them off as they are just plastic.
I then refitted it but not pushing in the clips where the pressure was being applied. Once I got the bezel off, turn the laptop back on and see if the light bleed has gone. You basically pull it up from the inside of the bezel. I used some plastic pry tools from amazon to help pry it off. įind the page that explains how to remove the display bezel. Click to expand.Here is the link to the manual.
0 kommentar(er)
